We all know that LED waterproof power supplies are power products with waterproof performance, but the reason why LED waterproof power supplies can be waterproof is mainly achieved through the method of gluing. Glue filling can not only extend the lifespan of LED waterproof power supply, but also play a good role in heat dissipation. So how is the LED waterproof power supply glued? Below, the technical personnel from Jiangmen LED waterproof power supply manufacturer will explain to you:

1、 Method of gluing LED waterproof power supply:

Before pouring the glue, it is necessary to mix the glue solution in a 1:1 ratio and thoroughly mix it evenly before sealing. Modulation vulcanization time usage method: 1. Measurement: Accurately weigh components A and B, and mix them according to the ratio.

2. Mixing: First, mix component A evenly, then add component B to the mixing container containing component A and mix evenly.

3. Pouring: After mixing evenly, seal the adhesive solution.

4. Curing: The sealed LED waterproof power supply is cured at room temperature. After initial curing, it can enter the next process, and complete curing takes 1-2 hours. In summer, the temperature is high and the curing process will be faster; The temperature is low in winter, and the curing process may be slower.

Attention: Once the mixed material is ready, it should be filled and sealed in a timely manner. Do not mix too much material at once to avoid waste.

2、 The reason why LED waterproof power supply can be waterproof is mainly achieved through the method of gluing.

Glue filling can not only extend the lifespan of LED waterproof power supply, but also play a good role in heat dissipation. So what are the precautions for LED waterproof power supply adhesive

1. Before weighing the glue, it should be mixed appropriately to disperse the pigment (or filler) that has sunk to the bottom into the glue solution, otherwise it will cause slow curing, uneven viscosity and color, and other phenomena.

2. The best accuracy for electronic scales is 1 gram to ensure accurate proportioning.

3. It is necessary to use up the adhesive solution within 10 minutes each time, otherwise the viscosity will gradually increase and the fluidity will deteriorate.

4. When using a container that has been glued again, it is necessary to clean the residual glue inside the container before continuing to glue, otherwise it will simply form filamentous substances inside the glue and have poor fluidity.

How is the LED waterproof power supply glued? Share it here. The quality of glue filling directly affects the waterproof quality of LED waterproof power supply, so it is very important to choose high-quality glue and grasp the method of glue filling.

Article source: Jiangmen LED waterproof power supply manufacturer http://www.gddpdz.com/